Resolved: the rollback command is not working with me

Hi Fatma!
Thanks for reaching out.

There are very few reasons that could lead to this problem. We believe there is a setting that, for some reason, has been switched on or off, and that’s what causes the issue here.

In the SQL editor of MySQL Workbench, there is the possibility to toggle the autocommit mode by pressing a single button. This is the third of the three icons seen in the red rectangle. If you’ve pressed this button, it means that this mode will be turned on, and each statement will be committed immediately.

Please check if it has been left intact and you can see the three icons within the red rectangle in color, just as it is shown in the picture above.

(When the button has been pressed, the autocommit mode will be toggled on, and the tick and the X button will probably appear grey.

If this is the case, please toggle off the autocommit button by pressing the third of the icons to see the tick

and the X button in blue again.)

Hope this helps.
Best,
Tsvetelin